HART-protocol OEM Transmitter Module for pressure transmitters
Popular sensors acceptable
- Self-stability and filter setup
- Backup and restore data
- Excellent EMC performance
The SE52H with HART-protocol is suitable for various sensors and converts input signals into 4~20mA analogue output signal.
Standard installation of the SE52H is for 2088 and BP 800 housing. Further versions are possible on request.
The SE52H can be programmed via three buttons.Following parameters can be adjusted: zero,span,decimal point,damping,
display mode,restore data and so on. For parmenter setting and visualization of measured value an optional liquid crystal
displays is available. The module is protected against miswiring and transient overvoltages.
Application areas
The SE52H may be used for a wide
variety of measure sensors:
- pressure sensors
- differential sensors
- load cells
- magnetic field sensors
- strain gauge
- resistor of 2/3/4 wires
Performance
- Wide voltage supply range:9-45VDC
- Self-stability and filter setup:Improve transmitter stability
- Freely linearity and temperature compensation:Min. 2 points, max. 16 points
- Self-learning function:Acceptability 1.5mV-3.6V signal input
- Popular sensors acceptable:E.g. Pressure, differential, load cell,Magnetic float,strain gauge etc.
- Backup and restore data:Convenient for using on the locale
- Excellent EMC performance:Suitable for harsh conditions
Operation
The HART module SE52H can be adjusted via three push buttons, PC with HARTTran software or PDA.
Display and push buttons.
The indication of the measured value as well as the configuration of the individual parameters occurs through a menu via the LCD. The individual functions can be set with the help of three push buttons.Besides in the display a bargraph is shown,which indicatesthe current precent input in per cent to the specified pressure range.
Following parameters can be adjusted:
unlock
PV=0
4 mA rerange
20 mA rerange
